Is there a definitive answer to what is the correct screwdriver to remove the front of the slider on the N95? An earlier thread hints at T6 or T5 but the former is too big and the latter too small and Torx don't come in half sizes.
It must be a different kind of screw but I can't afford to keep spending out on screwdriver sets to find out. Any help much appreciated.
GeoffT.
Think I read 5+ somewhere.
s.
I used a T5 to remove and replace the slider fascia after it managed to jump out of my jacket pocket and hit the tarmac in the car park at work! Fortunately I had a crystal case fitted at the time otherwise the damage would have been much worse, still it gave me a good excuse to change the housing from Plum to Graphite which not only looks great but was so stupidly easy to do, give it a go if you get the chance 😉
EDIT: The only thing I would say is that these kind of screws aren't really designed to be removed and replaced on a regular basis, that said they still require a fair amount of pressure to remove.
According to the N95 service manual the screws are not to be re-used, but are to be replaced each time as they contain some sort of locking stuff on them.
Also the gasket for the earpiece is also to be replaced each time.